QwikSeal 2-Part AC/R Leak Sealant & Drying Agent

2-Part Both a very efficient moisture remover and cutting-edge sealing technology are included in QwikSeal® QT2540. To guarantee that the sealant reacts exclusively with moisture present at the location of a leak, it is crucial to use an efficient drying agent.

Features

• QwikSeal® dries and seals systems from 1.5 to 6 tons, removes up to 26 drops of water and is compatible with all oils and refrigerant
• QwikSeal® bottles (clearly labeled Part A & Part B) are factory sealed to prevent contamination, and should not be opened until ready for use.
• QwikSeal® has been shown to completely seal leaks in vapor lines as large as 5.8 pounds per year; however, leaks in the liquid line greater than 0.1 pound per year may not completely seal.
• Our tests have shown that the sealing process can take as little as 10 minutes, but it could also take as much as 80 hours of run time. Higher oil circulation rates and higher system temperatures will accelerate the rate of sealing.

Instructions

NOTE: Always begin a sealing procedure with Part A (Drying Agent). Once opened, the entire contents of Part A should be transferred to the QwikInjector® and injected into the system as soon as possible.

1. Unscrew QwikInjector® top and fill with QwikSeal® Part A (Drying Agent).
2. Connect to the low side of the operating system FIRST.
3. Connect to the high side of the operating system LAST.
4. Open the valve on the manifold. The high side pressure will push the QwikSeal® into the low side of the system.
5. After the system has operated for at least 5 minutes, repeat steps 1-4 to add QwikSeal® Part B (Sealant) to the system.

• Product Data Sheet
• Product Safety Data Sheet
• QwikSeal Lab Test Results
• QwickProduct Catalog