AquaGuard AG-1200+ Magnetic Float Switch System for Metal & Plastic Secondary Drain Pans

Key Features:

• Universal Compatibility: Mounts easily to metal pans (without a lip) and non-AquaGuard plastic pans (with a lip) in under 10 seconds—no drilling required.
• High-Capacity Sensor: 5 amp rating ensures reliable operation in demanding environments.
• Innovative Clamp Design: Two-piece clamp allows secure, tool-free installation.
• Protective Housing: Shields the sensor from insulation and debris for long-term durability.
• Flexible Wiring Options: Supports both normally closed and normally open circuits.
• UL Listed (UL 508): Meets rigorous safety and performance standards.

Technical Specifications:

• Voltage Rating: 24VAC, 5.0A
• Trigger Depth: ¾ inch (vertical)
• Circuit Type: Normally Closed/Open
• Mounting Method: Clamp (no drilling)

• AG-1200+ Brochure
• Installation Guide
• Switch Selection Chart

Installation Instructions

• Disconnect power to the HVAC unit at the main panel before installation.
• Do not use on circuits exceeding 24 volts.
• Ensure the drain pan is clean and free of debris.

1. Position the Clamp: Place the two-piece clamp over the edge of the drain pan.
2. Secure the Switch: Finger-tighten the top thumb screw first, then the bottom screw to lock the switch in place.
3. Wire the Unit: Connect the float switch to the low-voltage circuit using either the normally closed or normally open configuration, depending on your system.
4. Test the Operation: Ensure wires are secured and do not interfere with float movement. Restore power and verify switch functionality.